Working principle of metal crusher

According to its working principle, Metal grinder can be roughly divided into two types: one: the use of dual-axis or single-axis low-speed rotation, the use of cutters to cut, cut, tear, pull materials. It is transmitted to the driven shaft through the gear change, so that the moving cutter of the drive shaft moves relative to the stationary cutter head on the housing. The helical tooth cutter on the drive shaft is staggered, so that after the material enters, it is squeezed, torn and cut at the same time, so that the material is broken. Two: The use of high-speed rotating impeller to tear and break long metal chips, high-speed rotation (about 1000 RPM) of the main shaft is connected with a number of round steel plates, round plate with the main shaft rotation. The round plate is equipped with 4 to 6 small shaped gears cast with manganese steel. The pinion turns freely on its own shaft. The long and messy metal chips enter the machine from the top, are twisted by the gear on the high-speed rotating steel plate, and tear into small pieces, and the size of the screen hole can be selected according to the size of the broken particles required by the metal chips.
The metal crusher uses the basic principle of the motor driven by the wind wheel extrusion, driven by the high-speed high-torque motor, the broken material can be fully and effectively broken in the crushing chamber, and the broken material will be torn into the specification of the broken material. The broken material is separated from the non-paint bucket by the air rotation sorting system, and the whole system is equipped with a dust removal device to minimize the dust pollution hazards generated in the production process. The equipment mainly has the advantages of high output, low energy consumption, high efficiency, uniform discharge and so on. And in the use of the equipment, low noise, no pollution, simple operation, easy maintenance.